Leaks & worn parts
Roof Flashing Repair in Brandon, MS
Flashing is the metal that seals the joints on a roof — around chimneys, along walls, beside skylights and at the edges. When it loosens, rusts or loses its sealant, water gets behind it. Call to describe the leak and ask about flashing repair from an independent roofer serving Brandon 39042 and nearby areas.
Providence Roofing is not a roofing contractor. Your call may be connected with an independent roofing provider. How this works
Have this ready when you call
- Your street address or neighborhood, and ZIP code
- What you are seeing, and when it started
- Whether water is coming in right now
- The roof's age and material, if you know them
You tell the roofer these things by phone. This website has no forms and stores nothing about you.
The problem
What is roof flashing, and how does it fail?
Shingles shed water well on an open slope. They cannot seal a joint on their own, so wherever the roof meets something else — a chimney, a dormer wall, a skylight, a second-story wall — metal flashing is layered in to carry water past the joint.
Flashing fails in a few predictable ways. Sealant dries and cracks. Fasteners work loose. Metal corrodes. A chimney settles a fraction of an inch and opens a gap. Sometimes old flashing was simply left in place when the roof was last re-shingled. Any of these lets water run behind the metal instead of over it.
Flashing leaks are among the most common reasons people call about roof repair in Brandon, and they are usually fixable without touching the rest of the roof.
Warning signs
Signs of a flashing problem
Flashing leaks tend to show up near an edge or a joint rather than in the middle of a room.
- A leak near a chimney, a fireplace wall or a skylight
- A stain where a lower roof meets an upper wall
- Rust streaks on metal or on the shingles below it
- Metal that has lifted, bent or pulled away from the wall
- Old, cracked caulk or tar smeared over a joint
- A leak that appears mainly in wind-driven rain
Brandon, Mississippi climate
Why flashing takes a beating here
Metal and masonry expand and contract at different rates. Through a Mississippi summer a chimney, the roof deck beside it and the flashing between them all move a little every day, and that movement slowly works sealant loose.
Humidity and frequent rain do the rest: joints stay wet longer, and unprotected steel rusts. Wall and chimney junctions also collect a lot of runoff in a downpour, so a small gap there lets in more water than the same gap would elsewhere.
What to expect
What a flashing inspection and repair may include
A roofer will normally want to see each type of flashing on the roof, not just the one nearest the stain.
Checking each joint
Step flashing along walls, counter-flashing at the chimney, skylight flashing, drip edge and any metal valleys.
Looking behind the surface
Whether the metal is lapped correctly under the shingles and whether counter-flashing is still set into the mortar.
Testing if needed
Running water over one joint at a time to see which one lets it through.
Explaining the options
Resealing, re-securing, replacing one section, or rebuilding the flashing around a chimney — and how long each is likely to last.
Sealant on its own is often a short-term fix. Ask the roofer whether the repair replaces metal or only reseals it.
Repair or replace
Flashing repair or a bigger job?
Flashing work is usually local to one joint. It becomes part of a larger project in a few situations.
A repair is usually enough when
- One joint is leaking and the shingles around it are in good condition
- The metal is sound and only needs to be re-secured or resealed
- A single section can be replaced without disturbing much of the roof
Replacement is worth discussing when
- Flashing is corroded in several places on an older roof
- The shingles beside it are too brittle to lift without breaking
- The roof is due for replacement anyway — new flashing is normally part of that work
Describe the leak and ask about flashing
Call and say where the stain is in relation to the chimney, skylight or wall. You may be connected with an independent roofing provider covering Brandon, MS 39042. If the leak runs along the line where two roof slopes meet, the roof valley leak page is the better match.
Providence Roofing is not a roofing contractor. Your call may be connected with an independent roofing provider. How this works
What happens on the call
- Say where you are and what is wrong with the roof.
- Answer a few questions about the problem.
- Discuss next steps with the roofing provider who takes the call.
If anyone is in immediate danger — a fallen power line, a fire, a structural collapse or an injury — call 911 first.
Questions
Roof Flashing Repair: common questions
Can leaking flashing just be caulked?
Sealant can buy time, and for a hairline gap it may be all that is needed. A lasting repair usually depends on metal that is correctly overlapped so water is carried out and over the shingles, with sealant as the backup rather than the main defence.
My roof is fairly new. Why would the flashing leak?
Age is not the only cause. Flashing that was reused from the previous roof, a missed overlap or a joint that relied on sealant alone can all leak early. An inspection will show which it is.
Is a leak at the chimney always a flashing problem?
No. Water can also enter through a cracked chimney crown, a missing cap, porous brick or a rusted chase cover. A roofer can tell you whether the roof side is at fault or whether a mason or chimney specialist is the right call.
Keep reading
Related roofing help
Roof Leak Repair
Ceiling stains, attic drips and damp insulation — where leaks usually start and what a repair visit covers.
Read moreRoof Valley Leak Repair
Leaks along the channel where two slopes meet — the part of the roof that carries the most water.
Read moreBrandon, MS 39042
The primary service area: Crossgates, Easthaven Estates, Eastgate, Hunters Woods and Pecan Ridge.
Read more
Prefer to see the number and how calls are handled first? The contact page has both, and the full list of roofing services covers every other problem.
General information only. This page describes common roofing problems in general terms. It is not an inspection, a diagnosis or an estimate for your home. The condition of a specific roof can only be judged by a qualified professional on site. For insurance questions, contact your insurer or agent.